Crash test dummy: Encyclopedia II - Crash test dummy - Dummy evolution

Crash test dummy - Dummy evolution

The information gleaned from cadaver research and animal studies had already been put to some use in the construction of human simulacra as early as 1949, when "Sierra Sam" was created by Samuel W. Alderson at his Alderson Research Labs (ARL) and Sierra Engineering Co. to test aircraft ejection seats and pilot restraint harnesses. This testing involved the use of high acceleration to 1000 km/h (600 mph) rocket sleds, beyond the capability of human volunteers to tolerate. In the early 1950s, Alderson and Grumman produced a dummy which was used to conduct crash tests in both motor vehicles and aircraft.

Alderson went on to produce what it called the VIP-50 series, built specifically for General Motors and Ford, but which was also adopted by the National Bureau of Standards. Sierra followed up with a competitor dummy, a model it called "Sierra Stan," but GM, who had taken over the impetus in developing a reliable and durable dummy, found neither model satisfied its needs. GM engineers decided to combine the best features of the VIP series and Sierra Stan, and so in 1971 Hybrid I was born. Hybrid I was what is known as a "50th percentile male" dummy. That is to say, it modeled an average male in height, mass, and proportion. The original "Sierra Sam" was a 95th percentile male dummy (heavier and taller than 95 percent of human males). In cooperation with the Society of Automotive Engineers (SAE), GM shared this design, and a subsequent 5th percentile female dummy, with its competitors.

Since then, considerable work has gone into creating more and more sophisticated dummies. Hybrid II was introduced in 1972, with improved shoulder, spine, and knee responses, and more rigorous documentation. Hybrid II became the first dummy to comply with the American Federal Motor Vehicle Safety Standard (FMVSS) for testing of automotive lap and shoulder belts. In 1973, a 50th percentile male dummy was released, and the National Highway Transportation Safety Administration (NHTSA) [2] undertook an agreement with General Motors to produce a model exceeding Hybrid II's performance in a number of specific areas.

Though a great improvement over cadavers for standardized testing purposes, Hybrid I and Hybrid II were still very crude, and their use was limited to developing and testing seat belt designs. A dummy was needed which would allow researchers to explore injury-reduction strategies. It was this need that pushed GM researchers to develop the current Hybrid line, the Hybrid III family of crash test dummies.

Adapted from the Wikipedia article "Dummy evolution", under the G.N U Free Docmentation License. Please also see http://en.wikipedia.org/wiki