Digital Subscriber Line: Encyclopedia II - Digital Subscriber Line - Equipment

Digital Subscriber Line - Equipment

The subscriber end of the connection consists of a DSL modem. This converts data from the digital signals used by computers into a voltage signal of a suitable frequency range which is then applied to the phone line.

In the early days of DSL, installation required a technician to visit the premises. A "splitter" was installed near the demarcation point, from which a dedicated data line was installed. Today, many DSL vendors offer a self-install option, in which they ship equipment and instructions to the customer. In this case, since no changes are made to the cable plant on the customer premises, all the phone wires are carrying both POTS and DSL signal frequencies; therefore the customer generally needs to plug a DSL filter into each telephone outlet. However, this can sometimes cause degradation of the DSL signal (especially if more than 5 analogue devices are connected to the line) because the DSL signal is present on all telephone wiring in the building. A way to circumvent this is to install one filter upstream from all telephone jacks in the building, except for the jack to which the DSL modem will be connected. Since this requires wiring changes by the customer and may not work on some (poorly designed) household telephone wiring, it is rarely done. It is usually much easier to install filters at each telephone jack that is in use.

At the exchange a digital subscriber line access multiplexer (DSLAM) terminates the DSL circuits and aggregates them, where they are handed off onto other networking transports. It also separates out the voice component.

Adapted from the Wikipedia article "Equipment", under the G.N U Free Docmentation License. Please also see http://en.wikipedia.org/wiki